You may notice that the time pointer is loose or is moving around too much.If you find your pointer is loose, simply tighten the screw that holds the timer in place so that it doesn’t wiggle around. Take them off and inspect them and look for twists in them. When the trippers are done up, you shouldn’t be able to move them with your hands. If the trippers are loose, then they could slip and cause issues with the pump turning on/off at the correct times. If the clock was already showing the correct time, check the On/Off Trippers (Pointers) are set to the correct time and are not loose. Reset the clock on the timer to the correct time to get it back to the desired on/off times.
When the power goes out, the timer stops. Timer Switching On/Off at the Wrong TimesĪ timer that switches on and off at the wrong times usually occurs after a power outage. Jump to the troubleshooting steps below to fix the issue.
Other problems causing this could be the yellow clock dial isn’t located correctly, wiring is loose, the gears are stripped, damaged or partially jammed or even the clock motor. If there has been a recent power outage, the clock will have stopped and you’ll need to reset the clock to the correct time. Did the power recently go out or has the circuit breaker tripped? If the pool timer is not keeping the correct time or losing time, there may be a simple fix. In this case it’s likely the On/Off trippers, loose wiring, the clock face not being located correctly or a faulty pump. Sometimes you will find the timer appears to be working, that is the clock dial is turning and you can see the gears behind the clock turning, but the pump isn’t being switched on or off. If the timer clock is not turning on your pool pump timer, it’s either the timer itself has a fault or there’s no power to the timer. The clock not turning on your Intermatic pool timer is a common issue. Power to the Timer But Timer Not Working or Not Working Properly.
POOL TIME CLOCK HOW TO
0 kommentar(er)
